Quickie Groove Informacje Techniczne Pobierz pdf (Strona 19)

Quickie Groove 19

.EMS

5.5 Drive wheel suspension GROOVE F/R

The GROOVE F/R has an effective and adjustable drive

wheel suspension system as a standard feature. To match your

requirements on drive comfort, the tension of the springs at the

damper can be adjusted.

Turning the aluminium ring on the bottom of the spring

downwards will soften your ride, adjusting the aluminium ring

in a higher position will harden it. This option is to be used

to match the different user weights to the suspension system.

(Fig. 5.7). We recommend the suspension adjustments are done

equally on the left and right side of the chair.

5.6 Control joystick unit position

Depending on your chosen control system, there are two

principles of control systems: Quickie VR2 and Quickie R-net

controls (for details please see the controls section 7). The remote

is mounted on a sliding mechanism which enables the control to

be moved forwards and backwards. When the most comfortable

position has been selected, secure the slider by tightening the

locking screw. Ensure the locking screw is fully tightened prior

to use and especially when transporting your wheelchair.

5.7 Armrests

5.7.1 Armrests-removing

The armrests on both sides of the wheel chair can be moved to

allow side transfer. (For hand control removal see section 5.6)

Please refer to your appropriate armrest type.

Single Post Armrest (Comfort, Rehab and Recaro Seat):

Release the handle screw on the side of the armrest receiver and

remove armrest (Fig. 5.8).

Flip-back armrest (Perfect Fit seat):

For side transfer flip the armrest all the way up until it goes into

its mechanical stop. This frees your space for side transfer.

Reclining armrest (Perfect Fit Seat):

Unlock the quick release mechanism at the bottom front pivot of

the armrest. Lift the armrest off the receiver. You can now turn

it to the outside, flip it backwards or release the rear part of the

armrest to take it fully off (Fig. 5.9).

5.7.2 Armrests-replacment

Please refer to your appropriate armrest type.

Single Post Armrest (Comfort, Rehab and Recaro Seat):

Place the armrest tube in the armrest receiver. Fix and tighten it

with the handle screw on the side of the armrest receiver (Fig.

5.8).

Flip-back armrest (Perfect Fit seat):

Flip the armrest all the way down until it sits on its mechanical

stop. Guide it in its downward movement and do not let it fall

on its own.

Reclining armrest (Perfect Fit Seat):

If you have taken it fully out, fit the rear stem into the round

receiver at the back rest. Then lower the armrest and guide the

front tube until it locks into the retaining tube. Lock it with the

quick release mechanism (Fig. 5.9).

5.7.3 Adjusting the armrest width (Recaro, Rehab and

Comfort Seat only)

To adjust the width loosen the

two screws (10mm spanner)

as shown in (Fig. 5.10) move

the armrest receiver brackets

to the desired position and

tighten the screws firmly

prior to use. The steel part

must always be located in

both aluminium clamp halves

Fig. 5.7

Fig. 5.8

Fig. 5.9

Fig. 5.10

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 65 66

Komentarze do niniejszej Instrukcji

Brak uwag

Quickie Groove Informacje Techniczne Strona 19

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Quickie Groove